1. Install the regulator and motor assembly rear. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the glass assembly - rear door. Rear Door Glass > INSTALLATION 3. Install the sealing cover - rear door. 4. Install the trim panel - rear door. Door Trim > INSTALLATION 5. Connect the ground terminal to battery sensor. NOTE |
InspectionDtc p0512 starter (switch) request circuit
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Failure of engine to startCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:Engine Electrical System ENGI ...