1. Install the front exhaust pipe assembly. NOTE: Use a new gasket. 2. Temporarily tighten the nuts which hold front exhaust pipe assembly to cylinder heads. 3. Install the bolts, springs and nuts securing the rear exhaust pipe to the front exhaust pipe assembly. NOTE: Use a new gasket. Tightening torque: 18 N·m (1.8 kgf-m, 13.3 ft-lb) 4. Tighten the bolts which hold front exhaust pipe assembly to hanger bracket. Tightening torque: 30 N·m (3.1 kgf-m, 22.1 ft-lb) 5. Tighten the nuts which hold the front exhaust pipe assembly to the cylinder heads in the numerical sequence as shown in the figure. Tightening torque: 30 N·m (3.1 kgf-m, 22.1 ft-lb) 6. Connect the front oxygen (A/F) sensor connector (A) and fasten the harness using clips (B). 7. Connect the rear oxygen sensor connector (C), and fasten the harness using the bracket (D) and (E). 8. Install the under cover. Front Under Cover > INSTALLATION 9. Lower the vehicle. 10. Connect the ground terminal to battery sensor. NOTE |
Installation
1. REAR GATE PANELCAUTION:The panel - rear gate is heavy. When removing and installing it, always work in a team of two or more persons.1. Install the hinge - rear gate to the vehicle body.2. Temporarily install the panel - rear gate to the hinge - rear gate.NOTE:When installing, make sure that a un ...