1. Install the cushion rubber and the rear exhaust cover to the vehicle body. Tightening torque: 10 N·m (1.0 kgf-m, 7.4 ft-lb) 2. Install the muffler to the cushion rubber. 3. Install the bolts and self-locking nuts securing the rear exhaust pipe to the muffler. NOTE: • Use a new gasket and self-locking nut. • After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing. Tightening torque: 48 N·m (4.9 kgf-m, 35.4 ft-lb) 4. Lower the vehicle. |
Removal
1. Remove the collector cover.(1) Carefully pull up the rear of collector cover at two positions (A).(2) Carefully pull up the front of collector cover at two positions (B) while moving it forward.2. Disconnect the ground terminal from battery sensor. NOTE3. Disconnect the connector (A) from the ma ...