Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Bring the front seat inside the vehicle. CAUTION: Be careful not to damage the body. 2. Connect the connectors located under the front seat. 3. Install the seat assembly. CAUTION: Tighten the slide rail assembly installing bolts in the order as shown in the figure, in several steps by gradually increasing the torque until they reach the specified torque.
Tightening torque: Front seat assembly: 53 N·m (5.4 kgf-m, 39.1 ft-lb) 4. Connect the ground terminal to battery sensor. NOTE 5. Install the headrest assembly - front. |
Assembly
CAUTION:• Do not confuse the harness routing in the reverse side of the seat cushion. Assembling with harnesses improperly routed may cause the harness to get caught and short out.• If the ...
Inspection
1. SEAT COVERCheck that there is no tear or fray on the cover COMPL - front backrest and the cover - front seat cushion.NOTE:• If the door side of the cover COMPL - front backrest is torn or fra ...
Other materials:
List of diagnostic trouble code (dtc) list
DTCItemReferenceB2300REAR RADAR CIRCUIT LOW Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2300 REAR RADAR CIRCUIT LOWB2301REAR RADAR CIRCUIT HIGH Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2301 REAR RADAR CIRCUIT HIGHB2304REAR RADAR ON-OFF SWITCH STUCK Diagnostic ...
