Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

1. SEAT HEATER MODULE - FRONT

1. Affix the seat heater module - front to the pad assembly.

CAUTION:

If the cover - front cushion is removed, make sure to replace the hang wire on the cover - front cushion side with a new wire.

When replacing the seat cover, be careful not to damage the occupant detection sensor while installing the hog ring.

When removing or replacing the seat cover, perform “Occupant Detection System Inspection” after installing the seat to check if the occupant detection system operates normally. PRE-DELIVERY INSPECTION (PDI) PROCEDURE

If the seat heater module is removed, replace the seat cushion pad & frame assembly with a new part.

If the seat heater module is reused, remove the polyurethane section from the reverse side completely.

Double-sided tape:

NITTO DENKO 501L or equivalent

2. Assemble the front seat. Front Seat > ASSEMBLY

3. Install the front seat.

Tightening torque:

53 N·m (5.4 kgf-m, 39.1 ft-lb)

2. SEAT HEATER SWITCH - FRONT

Install the heater control assembly. Control Panel > INSTALLATION

3. SEAT HEATER MODULE - REAR

1. Affix the seat heater module - rear to the pad assembly.

Double-sided tape:

NITTO DENKO 501L or equivalent

2. Assemble the rear seat. Rear Seat > ASSEMBLY

3. Install the rear seat. Rear Seat > INSTALLATION

4. SEAT HEATER SWITCH - REAR

1. Install the seat heater switch - rear.

2. Install the end cover - console box.

3. Install the battery sensor to the ground terminal. NOTE

5. SEAT HEATER UNIT - REAR

Sedan model

1. Install the seat heater module - rear.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

2. Install the trim panel - rear pillar UPR RH. Rear Quarter Trim > INSTALLATION

OUTBACK model

1. Install the seat heater module - rear.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

2. Install the trim panel - rear apron RH. Rear Quarter Trim > INSTALLATION

6. SEAT HEATER RELAY AND FUSE

1. Install the seat heater relay & fuse.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

2. Install the cover assembly - instrument panel LWR driver.

3. Connect the ground terminal to battery sensor. NOTE

Inspection
1. WIRING DIAGRAMRefer to “Seat Heater System” in the wiring diagram.• Front: Seat Heater System > WIRING DIAGRAM• Rear: Seat Heater System > WIRING DIAGRAM2. DIAGNOSTIC CHAR ...

Communication system
...

Other materials:

Installation
1. Install the front exhaust pipe assembly.NOTE:Use a new gasket.2. Temporarily tighten the nuts which hold front exhaust pipe assembly to cylinder heads.3. Install the bolts, springs and nuts securing the rear exhaust pipe to the front exhaust pipe assembly.NOTE:Use a new gasket.Tightening torque:1 ...

© 2017-2024 Copyright www.sulegacy.com