CAUTION: • When installing the motor assembly - sunroof, do not allow the cable assembly to move. • For installation of the stereo camera cover, refer to “INSTALLATION”, “Stereo Camera” in the “EyeSight” section and observe the precautions for installation. Stereo Camera > INSTALLATION 1. Install the motor assembly - sunroof. Tightening torque: 5.4 N·m (0.6 kgf-m, 4.4 ft-lb) 2. Install the overhead console. (Models without EyeSight) Spot Map Light > INSTALLATION 3. Install the stereo camera cover assembly. (Models with EyeSight) Stereo Camera > INSTALLATION 4. Connect the ground terminal to battery sensor. NOTE 5. Perform the initialize operation. Sunroof Control System > OPERATION 6. Check the operation of sunroof by following the table below.
|
Installation
1. Clean the crankshaft thread using compressed air.2. Install the crank pulley.3. Apply engine oil to the crank pulley bolt seat and thread.4. Use the ST to lock the crank pulley, and tighten the crank pulley bolt.NOTE:After tightening, if engine oil is spilt onto the crank pulley bolt or the crank ...