CAUTION: If the hook - rear seat is disconnected from the vehicle body, make sure to replace the hook - rear seat with a new part to prevent the decline of the fixed force of the seat. 1. Before installation, inspect the following items and replace any faulty part with a new one. • Curtain airbag sensor or connector is damaged. • Curtain airbag module has been activated. 2. Install the curtain airbag sensor. CAUTION: • Do not reuse the bolt and nut. Always replace with the specified new bolts and nuts. • When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 3. Install the cover side sill - rear and the trim panel - rear pillar LWR. 4. Install the side pad assembly - backrest. Tightening torque: 53 N·m (5.4 kgf-m, 39.1 ft-lb) 5. Install the rear seat cushion assembly. 6. Connect the ground terminal to battery sensor. NOTE |
Installation
1. LOW-PRESSURE HOSECAUTION:• If the hose and pipe has been replaced, add an appropriate amount of compressor oil to the compressor. Compressor Oil > ADJUSTMENT• Do not start the engine before charging refrigerant.• If the engine is started with no refrigerant charge, replace the ...