1. Before installation, inspect the following items and replace any faulty part with a new part. • The front door impact sensor or connector is damaged. • Inner panel area of the panel assembly - front door is deformed. • Plate - door is deformed. • Side airbag module has been activated. 2. Install the front door impact sensor. CAUTION: • Do not reuse the bolt and nut. Always replace with the specified new bolts and nuts. • Thoroughly clean the sensor mounting area before installing the front door impact sensor. • When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 3. Install the sealing cover. 4. Install the trim panel - front door. 5. Connect the ground terminal to battery sensor. NOTE |
Dtc u0427 invalid data received from vehicle security control module
DTC DETECTING CONDITION:Defective data was transmitted from keyless access CM.TROUBLE SYMPTOM:Cooperation control of keyless access does not operate properly.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.Was the basic diagnostic procedure performed up to STEP 8- Diagnostic Procedure ...