CAUTION: If the steering wheel and steering angle sensor are removed, perform “VDC sensor midpoint setting mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT 1. Before attaching a new roll connector, apply a thin coat of grease contained in the connector onto the areas shown by the arrows. 2. Install the cover assembly - column. 3. Install the roll connector. 4. Align the center position of the steering roll connector. Roll Connector > ADJUSTMENT 5. Install the steering wheel. Tightening torque: Steering wheel: 39 N·m (4.0 kgf-m, 28.8 ft-lb) Clearance: Between cover assembly - column and steering wheel: 4 — 6 mm (0.16 — 0.24 in) 6. Install the driver’s airbag module. Driver’s Airbag Module > INSTALLATION 7. Connect the ground terminal to battery sensor. NOTE 8. Perform the neutral position setting of the steering angle sensor. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT |
Electronic parking brake indicator light
Parking brake indicator
The light illuminates with the parking
brake applied while the ignition switch is
in the "ON" position. It turns off when the
parking brake is fully released.
Electronic parking brake system
warning
WARNING
When you release the electronic
parking b ...