Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Airbag system / Seat cushion airbag module / Installation

CAUTION:

• Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION

• Do not allow harness and connectors to interfere or get tangled up with other parts.

1. Before installation, inspect the following items and replace any faulty part with a new one.

• Airbag module is cracked or deformed.

• Frame assembly - front seat cushion is cracked or deformed.

• Harness and/or connector is cracked, deformed or open.

• Harness wire is exposed.

• Installation of seat cushion airbag module is difficult due to the condition of the frame assembly - front seat cushion.

2. Install the seat cushion airbag module.

CAUTION:

• Be careful that the end of airbag module is not turned over.

• Be sure to insert the connector in until it is locked.

• Press in the connector securely. Then pull it gently to make sure that it is locked.

Tightening torque:

6 N·m (0.6 kgf-m, 4.4 ft-lb)

3. Assemble the front seat. Front Seat > ASSEMBLY

CAUTION:

• After assembling the seat cushion, make sure that the two-dimensional codes (two positions) attached on the seat cushion airbag module can be seen. If it is not assembled correctly, the seat cushion airbag may not operate properly.

• After assembling the seat, operate the reclining and sliding mechanisms to check that the airbag harness is not caught.

4. Install the front seat assembly to the body. Front Seat > INSTALLATION

5. Connect the ground terminal to battery sensor. NOTE

Removal

CAUTION:Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION1. Turn the ignition switch to OFF.2. Disconnect ...

Side airbag module

...

Other materials:

Inspection
1. LATCHPull the emergency lever to check that the latch operates properly.If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace the power rear gate auto closer.2. ACTUATORPreparation tool:Circuit tester1. Check motor operation(1) Check the motor operation when battery ...