CAUTION: • Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION • Make sure that the side airbag module is installed as shown in the figure.
• Be careful not to stain or damage the cover COMPL - front backrest during assembly. • Do not reuse hog rings. • Secure the hog ring using hog ring pliers. • Install the hog rings to the specified points securely and make sure that there is no wrinkle or twisting on the cover COMPL - front backrest. 1. Before installation, inspect the following items and replace any faulty part with a new one. • Make sure that there is no foreign matter on side airbag module. • Front seat, airbag module and mounting bracket are damaged or deformed. • Harness and/or connector is cracked, deformed or open. • Harness wire is exposed. 2. Install the side airbag module to the frame assembly - front backrest. Tightening torque: 6 N·m (0.6 kgf-m, 4.4 ft-lb) 3. Assemble the front seat. Front Seat > ASSEMBLY CAUTION: After restoring the seat, operate the reclining and sliding mechanisms to check that the airbag harness is not caught. 4. Install the front seat assembly to the body. Front Seat > INSTALLATION 5. Connect the ground terminal to battery sensor. NOTE |
Monitor (if equipped)
To clean the audio/navigation monitor,
wipe it with a silicone cloth or with a soft
cloth. If the monitor is extremely dirty,
clean it with a soft cloth moistened with
neutral detergent then carefully wipe off
any remaining detergent.
CAUTION
Do not spray neutral detergent
...