Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: If the hook - rear seat is disconnected from the vehicle body, make sure to replace the hook - rear seat with a new part to prevent the decline of the fixed force of the seat.
1. Before installation, inspect the following items and replace any faulty part with a new part. • The side airbag sensor or connector are damaged. • Side airbag module has been activated. 2. Install the side airbag sensor. CAUTION: • Do not reuse the bolt and nut. Always replace with the specified new bolts and nuts. • When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 3. Install the seat belt retractor. Tightening torque: Front seat belt: General Description > COMPONENT 4. Install the cover side sill - front, cover side sill - rear, and the trim panel - center pillar LWR. 5. Install the rear seat cushion assembly. 6. Connect the ground terminal to battery sensor. NOTE |
Removal
CAUTION:• Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION• If the hook - rear seat is disco ...
Other materials:
Dtc p2006 tgv control stuck closed bank 1
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.STEPCHECKYESNO1.CHECK FOR ANY OTHER DTC ON DISPLAY.Is any other DTC displayed-Check th ...
