Subaru Legacy BN/BS (2015-2019) Owners Manual: Light control switch

Subaru Legacy BN/BS (2015-2019) Owners Manual / Instruments and controls / Light control switch

CAUTION

Use of any lights for a long period of time while the engine is not running can cause the battery to discharge.
Before leaving the vehicle, make sure that the light control switch is turned to the off position. If the vehicle is left unattended for a long time with the light control switch set to a position other than the off position, the battery may be discharged.

Models with "keyless access with push-button start system": The light control switch operates when the push-button ignition switch is in the "ACC" or "ON" position.

Regardless of the position of the light control switch, the illuminated lights are turned off when the push-button ignition switch is turned off.

Models without "keyless access with push-button start system": The light control switch operates when the key is inserted in the ignition switch.

Regardless of the position of the light control switch, the illuminated lights are turned off when the key is removed from the ignition switch.

NOTE The light control switch can be operated (except auto on/off headlights), even under the following conditions.

when the push-button ignition switch is turned off (models with "keyless access with push-button start system")
when the key is not inserted into the ignition switch (models without "keyless access with push-button start system")

If the driver's door is opened while the headlights are illuminated under such conditions, a chirp sound will inform the driver that the lights are illuminated.

Menu screens

Pull and hold the " /SET" switch to enter the menu screens when all of the following conditions are satisfied. The vehicle has been completely stopped. The select lever is in the ...

Headlights

To turn on the headlights, turn the knob on the end of the turn signal lever. " " position: The headlights are all off. " " position: Instrument panel illumination, headlights, parking lig ...

Other materials:

Removal
1. CVT MODEL1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Remove the panel - knee guard. Steering Column > REMOVAL4. Remove ...