Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: List

Item Name

Contents

Standard

Note

Trip Count

Time stamp information, trip counter

—

—

Count

Time stamp information, original counter identification information

—

—

Time Count

Time stamp information, time counter

—

—

R Sensor Signal

Output voltage value from rear vehicle height sensor

Approx. 2.5 V

Changes according to vehicle condition.

Not displayed for models without auto headlight beam leveler system.

Actuator Signal

Power supply voltage value to headlight beam leveler actuator

Not in operation: 0%

In operation: 10 — 90% (17 seconds)

Changes according to vehicle condition.

Not displayed for models without auto headlight beam leveler system.

ECU ACC

IG voltage condition of SRF CM

8 — 16 V

—

Indicator Signal

Meter indicator condition

Light off: Normal

Light up: Abnormal

Blinks 3 times at 2 Hz.: When blinking 3 times at 2 Hz

Blinks 2 times at 2 Hz.: When blinking twice at 2 Hz

Check Bulb: When checking bulbs

Fixed to OFF for models without auto headlight beam leveler system.

Vehicle speed signal

Vehicle speed condition

Show vehicle speed

—

H/L Lo Signal

Headlight (Lo) lighting condition

OFF: when unlit

ON: when lit

—

Headlight High Beam Signal

Headlight (Hi) lighting condition

OFF: when unlit

ON: when lit

—

Fog Light SW Signal

Front fog light switch status

OFF: when switch OFF

ON: when switch ON

—

Steering Angle Signal

Steering angle status

Displays steering angle

—

Shift Position Signal

Shift lever position

Displays shift lever position

—

SRF Status

SRF switch status

SRF Function ON: when switch ON

SRF Function OFF: when switch OFF

—

Fog Light Control Status

SRF operation status

LH/RH Light off: when all unlit

LH Light on: when left fog light is lit

RH Light on: when right fog light is lit

LH/RH Light on: when all lit

—

Operation
1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. ...

Subaru select monitor
...

Other materials:

Installation
1. Clean the crankshaft thread using compressed air.2. Install the crank pulley.3. Apply engine oil to the crank pulley bolt seat and thread.4. Use the ST to lock the crank pulley, and tighten the crank pulley bolt.NOTE:After tightening, if engine oil is spilt onto the crank pulley bolt or the crank ...

© 2017-2026 Copyright www.sulegacy.com