Subaru Legacy BN/BS (2015-2019) Service Manual: Malfunction indicator light does not come on

Subaru Legacy BN/BS (2015-2019) Service Manual / Engine (diagnostics)(h4do) / Malfunction indicator light / Malfunction indicator light does not come on

TROUBLE SYMPTOM:

When the ignition switch is turned to ON (engine OFF), malfunction indicator light does not illuminate.

STEP	CHECK	YES	NO
1.CHECK DTC.	Is DTC of LAN system displayed- Read Diagnostic Trouble Code (DTC) > OPERATION	Check the appropriate DTC using the “List of Diagnostic Trouble Code (DTC)”. List of Diagnostic Trouble Code (DTC)	Replace the meter case assembly of combination meter. Combination Meter

Procedure

1. Activation of malfunction indicator light Malfunction Indicator Light > ACTIVATION OF MALFUNCTION INDICATOR LIGHT↓2. Malfunction indicator light does not come on Malfunction Indicator Light ...

Activation of malfunction indicator light

1. When the ignition switch is turned to ON (engine OFF), the malfunction indicator light (A) in the combination meter illuminates.NOTE:If the malfunction indicator light does not illuminate, perform ...

Other materials:

Dtc p0032 a/f / o2 heater control circuit high bank 1 sensor 1
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE EZ (WITHOUT PUSH BUTTON ST ...