1. REGISTRATION (COMM CHECK) CAUTION: Because it will go back to Factory mode when the signal is weak, that you do not press the i button more than 2 seconds during a communication check. If it had returned to Factory mode, carrying out the CommCheck again. Each mode state can be confirmed in the “Subscription Status” in the current data display of SSM. 1. Replace the data communication module with a new part. 2. Check the LED of overhead console or stereo camera cover assembly illuminates in green. 3. Press and hold the i-button for 2 seconds or more. NOTE: When the subscription is completed, the telematics system will automatically activate. |
Dtc p2272 o2 sensor signal biased/stuck lean bank 2 sensor 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...