1. IMPACT SENSOR SETTING USING SUBARU SELECT MONITOR 1. Make an impact monitor setting. (1) Connect the Subaru Select Monitor to data link connector. NOTE: For detailed operation procedures, refer to “Application help”. (2) Turn the ignition switch to ON. (3) On «Start» display, select «Diagnosis». (4) On «Vehicle selection» display, input the target vehicle information and select «Confirmed». (5) On «Main Menu» display, select «Each System». (6) On «Select System» display, select «Body Control» and then select «Enter». (7) On «Select Function» display, select «Customize». (8) From the Customize item list, select «Impact sensor» or «Impact Sensor Setup». (9) Make an impact monitor setting. • When installing: ON • When removing: OFF (10) Make an impact monitor ON/OFF setting. • When installing: ON • When removing: OFF (11) Turn the ignition switch to OFF, and then remove the Subaru Select Monitor. |
Installation
CAUTION:• Do not start the engine before charging refrigerant.• If the engine is started with no refrigerant charge, replace the compressor assembly.• If the evaporator has been replaced, add an appropriate amount of compressor oil to the compressor. Compressor Oil > ADJUSTMENT&bu ...