1. INITIALIZE OPERATION CAUTION: If the switch is released during initialization operation, perform the procedure over again. 1. Turn the ignition switch to ON. 2. Completely tilt open the lid assembly - sunroof. 3. Release the switch once, and press and hold the tilt up switch or close switch again for approx. 3 minutes. 4. Initial learning mode will start to operate until the fully tilt closed position. The lid assembly - sunroof moves to the fully closed position, fully open position, and the fully closed position successively, and stops at the fully closed position. 5. Release the tilt up switch or the close switch, and turn the ignition switch to OFF. 6. Initial learning is completed. |
Inspection
1. CRANKSHAFT POSITION SENSOR1. Disconnect the ground terminal from battery sensor. NOTE2. Prepare an oscilloscope.3. While pressing the section (A) shown in the figure, move the lock lever (B) in the direction of the arrow to disconnect the connectors from the ECM in numerical order as shown in th ...