Subaru Legacy BN/BS (2015-2019) Service Manual: Power amplifier

Installation

1. Install the noise suppressor assembly.Tightening torque:12±3 N·m (1.2±0.3 kgf-m, 8.9±2.2 ft-lb)2. Install the trim panel - rear pillar UPR. (Sedan model) Rear Quarter Trim > INSTALLATION ...

Removal

NOTE:Remove the power amplifier assembly after sliding the passenger’s seat back and forth as necessary.1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the power amplifier ...

Other materials:

Inspection
1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.2. CHECK RELAY1. Measure the resistance between relay terminals.Terminal No.Inspection conditionsStandardCircuit1 — 2Always1 M- or more1 — 4AlwaysLess than 1 -1 — 2Apply battery voltage between t ...