Subaru Legacy BN/BS (2015-2019) Service Manual: Power rear gate drive unit

Installation

1. Install the power rear gate control module (PRG CM).NOTE:Connect the connectors in reverse order of removal.2. Install the trim panel - rear apron LH.3. Connect the ground terminal to battery senso ...

Removal

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the rod - power rear gate. Power Rear Gate Rod > REMOVAL3. Remove the ...

Other materials:

Inspection
1. Ball bearingReplace the ball bearing in following cases.• In case of broken or rusty ball bearings• In case of worn or damaged ball bearings• When the ball bearings fail to turn smoothly or emit noise in rotation after transmission gear oil has been applied.2. Transfer drive gea ...