Subaru Legacy BN/BS (2015-2019) Service Manual: Power rear gate rod

Installation

1. Install the power rear gate inner switch.2. Connect the ground terminal to battery sensor. NOTE ...

Removal

1. Hold the rear gate to the fully open position.2. Disconnect the ground terminal from battery sensor. NOTE3. Release the claws and then remove the cap - rear quarter pillar UPR LH.4. Remove the rod ...

Other materials:

Dtc p0340 camshaft position sensor "a" circuit bank 1 or single sensor
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Engine stalls.• Failure of engine to startCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM ...