Subaru Legacy BN/BS (2015-2019) Service Manual: Preparation tool
1. SPECIAL TOOL ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS | | 18355AA000 | PULLEY WRENCH | • Used for removing and installing water pump pulley. • Used with PULLEY WRENCH PIN SET (18334AA030). | | 18334AA030 | PULLEY WRENCH PIN SET | • Used for removing and installing water pump pulley. • Used together with PULLEY WRENCH (18355AA000). | | 18360AA040 | HANGER | • Used for removing and installing the water pipe assembly LH. • Used together with BOLT (18363AA050). | | 18363AA050 | BOLT | • Used for removing and installing the water pipe assembly LH. • Used together with HANGER (18360AA040). | | 18460AA050 | CHECK BOARD | Used for inspecting the radiator fan system. | | 73099SG000 | SPECIAL TOOL CONDENSER | Used for removing and installing the radiator. | | — (Newly adopted tool) | SUBARU SELECT MONITOR 4 | Used for setting of each function and troubleshooting for electrical system. NOTE: For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”. |
2. GENERAL TOOL TOOL NAME | REMARKS | Circuit tester | Used for measuring resistance, voltage and current. | Radiator cap tester | Used for checking radiator and radiator cap. | DST-i | Used together with Subaru Select Monitor 4. |
|
• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary ...
1. WATER PUMP(1)Water pump pulley(10)Preheater hose(19)Engine coolant temperature sensor(2)Water pump ASSY(11)Clip(20)Gasket(3)Gasket(12)Water pipe ASSY (4)Thermostat (engine side)(13)Thermostat (CVT ...
Other materials:
Preparation for overhaul procedure
1. Clean oil, grease, dirt and dust from the transmission.2. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.3. Tighten the drain plug using TORX® bit T70.NOTE:Use a new gasket.Tightening torque:44 N·m (4.5 kgf-m, 32.5 ft-lb) (aluminum gasket, ...