1. SPECIAL TOOL
2. GENERAL TOOL
NOTE: Referring to the data described below, prepare the materials to make a nozzle - windshield washer adjustment tool. Materials • Vertebra of wiper blade which is to be discarded • Vinyl tape Steps of making a front washer nozzle adjustment tool (1) Bend the vertebra at the position 25 mm (0.98 in) away from its end by 45°. (2) Bend the vertebra at the position 29 mm (1.14 in) away from the other end by 45°. (3) Double up the vertebra so that the longer end (29 mm (1.14 in)) comes upward. (4) Secure the vertebra with a vise (a) so that the tip clearance becomes 5 mm (0.20 in). (5) Bend the vertebra at the position approximately 90 mm (3.54 in) away from the bending point for the longer end. (6) Check that the tip clearance is 5 mm (0.20 in), and secure the vertebra with vinyl tape (b). |
Manual transmission
WARNING
Do not drive the vehicle with the
clutch disengaged (i.e., when the
clutch pedal is depressed) or
with the shift lever in the neutral
position. Engine braking has no
effect in either of these conditions
and the risk of an accident
is consequently ...