1. Clean the transmission exterior. 2. Attach the ST on the transmission assembly.
3. Remove the torque converter assembly. Torque Converter Assembly 4. Remove the transmission case cover on the transmission upper side. NOTE: Install using the following tightening torque. Tightening torque: 8 N·m (0.8 kgf-m, 5.9 ft-lb) 5. Place the transmission assembly on end. 6. When completely overhauling the transmission, refill approx. 10 L (2.6 US qt, 8.8 Imp qt) of CVTF through the transmission right side plug, and install the plug. Then, install the transmission case cover. CAUTION: Always use specified CVTF. Using other fluid will cause malfunction. General Description > SPECIFICATION NOTE: Use a new gasket. Tightening torque: 50 N·m (5.1 kgf-m, 36.9 ft-lb) |
High/low beam change (dimmer)
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light " " on the
combination
meter is also on.
To switch back to low beam, pull the lever
back to the center position.
High beam assist function (if ...