1. Clean the transmission exterior. 2. Remove the torque converter assembly. Torque Converter Assembly > REMOVAL 3. Attach the ST on the transmission.
4. Remove the transmission cover on the transmission upper side. NOTE: Install using the following tightening torque. Tightening torque: 8 N·m (0.8 kgf-m, 5.9 ft-lb) 5. Place the transmission assembly on end. |
Inspection
When the driving condition or starter motor operation is improper, first check the shift linkage for improper operation. If the shift linkage is functioning properly, check the inhibitor switch.1. Remove the collector cover.(1) Carefully pull up the rear of collector cover at two positions (A).(2) C ...