1. STOPPING KEYLESS ACCESS SYSTEM FUNCTION BY DOOR OPEN/CLOSE PROCEDURE 1. Check that the vehicle status is as follows: • Ignition switch OFF • One window is completely open • Keyless access system is activated (or disabled if re-activating) 2. Sit in the driver’s seat with the door closed and press the door lock switch to UNLOCK once. 3. Open the driver’s door within five seconds. 4. Within 5 seconds, with the driver’s door opened, slowly press the door lock switch to UNLOCK twice. 5. Within 10 seconds after finishing step 4), perform the closing > opening operation of the driver’s door twice. 6. Within 10 seconds after finishing step 5), with the driver’s door opened, slowly press the door lock switch to UNLOCK twice. 7. Within 10 seconds after finishing step 6), perform the closing > opening operation of the driver’s door once. 8. Within five seconds, close the driver’s door. NOTE: • Perform the same procedures to re-activate the keyless access system from the disabled condition. • If the driver’s door is opened or closed in step 4) and step 6), the cancel operation is disabled. 2. STOPPING KEYLESS ACCESS SYSTEM FUNCTION BY USING ACCESS KEY 1. Open the driver’s door, and then push the door lock knob forward (LOCK direction). 2. Press the lock button of access key and trunk/rear gate button simultaneously for five seconds or more. 3. The buzzer sounds for two seconds, and the function stops. NOTE: Perform the same procedures to re-activate the keyless access system from the disabled condition. |
Dtc p0125 insufficient coolant temperature for closed loop fuel control
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:Engine does not return to idle.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.STEPCHECK ...