Subaru Legacy BN/BS (2015-2019) Service Manual: Rear quarter glass

Installation

NOTE:Use the markings on the glass to apply adhesive and primer, and to install the dam rubber - rear gate and the spacer - rear gate.(a)Locating pin - rear gate(d)Marking for dam rubber - rear gate a ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - rear pillar UPR. Rear Quarter Trim > REMOVAL3. Remove the glass - rear quarter in the same procedure as for the ...

Other materials:

Installation
1. Install the purge control solenoid valve, and connect the connector and vacuum hose to the purge control solenoid valve.NOTE:Connect the vacuum hose as shown in the figure.(a)To intake manifold(b)To fuel pipe Tightening torque:19 N·m (1.9 kgf-m, 14.0 ft-lb)2. Install the air intake boot. ...