Subaru Legacy BN/BS (2015-2019) Service Manual: Rear regulator and motor assembly
1. Fabricate the cartridge nozzle tip as shown and set the sealant gun with the adhesive.(a)10 mm (0.39 in)(b)8 mm (0.31 in)(c)Sealant gun2. Smoothen and clean the adhesive surfaces of the glass - rea ...
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - rear door. Door Trim > REMOVAL3. Remove the sealing cover - rear door.4. Remove the glass assembly - rear door. ...
Other materials:
Inspection
1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandardFront LH: 1 — 2Except for front LH: 1 — 4When the switch is not pressedLess than 1 -When the switch is pressed1 M- or more2. Replace the switch assembly - door if the ins ...