Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
CAUTION: If the CVTF and engine coolant is spilt over exhaust pipe, wipe it off with cloth to avoid emitting smoke or causing a fire. 1. Disconnect the ground terminal from battery sensor. NOTE 2. Drain engine coolant. Engine Coolant > REPLACEMENT 3. Remove the clip (A), and loosen the clamps (B) and (C).
4. Remove the air intake boot assembly, and move it to the left side wheel apron.
5. Remove the harness clip.
6. Remove the engine coolant outlet hose. • Without CVTF cooler (air cool)
• With CVTF cooler (air cool)
7. Remove the CVTF inlet hose and outlet hose. • Without CVTF cooler (air cool)
• With CVTF cooler (air cool)
8. Remove the engine coolant inlet hose.
9. Remove the CVTF cooler (with warmer feature).
|
Assembly
1. Install the harness stay.Tightening torque:23 N·m (2.3 kgf-m, 17.0 ft-lb)2. Install the CVTF cooler (with warmer feature).Tightening torque:23 N·m (2.3 kgf-m, 17.0 ft-lb) ...
Other materials:
Dtc p0032 a/f / o2 heater control circuit high bank 1 sensor 1
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE EZ (WITHOUT PUSH BUTTON ST ...
