Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. Remove the transmission assembly. Automatic Transmission Assembly > REMOVAL 2. Remove the air breather hose. Air Breather Hose > REMOVAL 3. Remove the control valve body. Control Valve Body > REMOVAL 4. Remove the transmission harness. Transmission Harness > REMOVAL 5. Remove the turbine speed sensor. Turbine Speed Sensor > REMOVAL 6. Remove the secondary speed sensor. Secondary Speed Sensor > REMOVAL 7. Remove the primary speed sensor. Primary Speed Sensor > REMOVAL 8. Remove the inhibitor switch. Inhibitor Switch > REMOVAL 9. Remove the extension case. Extension Case > REMOVAL 10. Remove the transfer clutch assembly. Transfer Clutch > REMOVAL 11. Remove the transfer driven gear assembly. Transfer Driven Gear > REMOVAL 12. Remove the parking pawl. Parking Pawl > REMOVAL 13. Remove the reduction driven gear assembly. Reduction Driven Gear > REMOVAL 14. Remove the oil pan and oil strainer. Oil Pan and Strainer > REMOVAL 15. Remove the transmission control device. Transmission Control Device > REMOVAL 16. Remove the transmission case. Transmission Case > REMOVAL 17. Remove the reduction drive gear. Reduction Drive Gear > REMOVAL 18. Remove the primary pulley, secondary pulley and variator chain. Primary Pulley and Secondary Pulley > REMOVAL 19. Remove the reverse brake assembly. Reverse Brake Assembly > REMOVAL 20. Remove the forward clutch assembly. Forward Clutch Assembly > REMOVAL 21. Remove the drive pinion shaft assembly. Drive Pinion Shaft Assembly > REMOVAL 22. Remove the oil baffle.
23. Remove the lock plates on both sides.
24. Remove the differential side retainers using ST. NOTE: • When the wrench COMPL retainer interferes with the converter case, align the cutout portion with the interference part. • Support the differential case assembly by hand to avoid damaging the retainer mounting hole of the converter case. • Keep the left and right differential side retainers and left and right bearing outer races by attaching tags or in similar ways to make it possible to identify RH and LH sides.
25. Remove the front differential assembly while being careful not to damage the attachment part of the retainer.
26. Remove the oil seals and O-rings from both differential side retainers. Front Differential Assembly > DISASSEMBLY |
Adjustment
1. Using the ST, screw-in the retainer until resistance is felt.NOTE:RH side should be screwed-in more than LH side.ST 18658AA020WRENCH COMPL RETAINER2. Remove the remaining liquid gasket from the ...
Other materials:
Caution
1. The airbag system wiring harness is routed near the TCM.CAUTION:• All the airbag system wiring harnesses and connectors are colored yellow. Do not use an electric test equipment to check these circuits.• Be careful not to damage the airbag system wiring harness when performing diagnos ...
