Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
CAUTION: Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, replace with a new part. 1. Remove the transmission assembly. Automatic Transmission Assembly > REMOVAL 2. Remove the primary speed sensor.
3. Disconnect the harness connector from primary speed sensor.
|
Inspection
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the clip (A), and loosen the clamps (B) and (C).3. Remove the air intake boot from the throttle body, and move it to the left side ...
Other materials:
Dtc p0711 transmission fluid temperature sensor "a" circuit range/performance
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Excessive shift shock• Shift characteristics malfunctionNOTE:For the diagnostic procedure, perform the diagnosis according to DTC P0712 and P0713. Diagnostic Procedure with Diagnostic ...
© 2017-2024 Copyright www.sulegacy.com
