Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr580) / Reduction drive gear / Removal

1. Remove the transmission assembly. Automatic Transmission Assembly > REMOVAL

2. Remove the air breather hose. Air Breather Hose > REMOVAL

3. Remove the control valve body. Control Valve Body > REMOVAL

4. Remove the transmission harness. Transmission Harness > REMOVAL

5. Remove the turbine speed sensor. Turbine Speed Sensor > REMOVAL

6. Remove the secondary speed sensor. Secondary Speed Sensor > REMOVAL

7. Remove the primary speed sensor. Primary Speed Sensor > REMOVAL

8. Remove the inhibitor switch. Inhibitor Switch > REMOVAL

9. Remove the extension case. Extension Case > REMOVAL

10. Remove the transfer clutch assembly. Transfer Clutch > REMOVAL

11. Remove the transfer driven gear assembly. Transfer Driven Gear > REMOVAL

12. Remove the parking pawl. Parking Pawl > REMOVAL

13. Remove the reduction driven gear assembly. Reduction Driven Gear > REMOVAL

14. Remove the oil pan and oil strainer. Oil Pan and Strainer > REMOVAL

15. Remove the transmission control device. Transmission Control Device > REMOVAL

16. Remove the transmission case. Transmission Case > REMOVAL

17. Remove the reduction drive gear shims, spring retainers, and dish plates.

18. Remove the reduction drive gear.

Adjustment

1. Remove the spring retainers and reduction drive gear shims.2. Install the transmission case, and secure it with four or five bolts.Tightening torque:22 N·m (2.2 kgf-m, 16.2 ft-lb)3. Measure ...

Other materials:

Replacement
1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle.3. Remove the front under cover. Front Under Cover > REMOVAL4. Clean the transmission exterior.5. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.CAUTION:• Immedi ...