1. Remove the transmission assembly. Automatic Transmission Assembly > REMOVAL 2. Remove the inhibitor switch. Inhibitor Switch > REMOVAL 3. Remove the oil pan and oil strainer. Oil Pan and Strainer > REMOVAL 4. Shift the manual plate to “N” range, and remove the spring pin. NOTE: Prevent the spring pin from dropping in the transmission using paper towel etc. 5. Remove the detent spring. 6. Remove the bolt, and remove the shifter arm shaft. NOTE: Do not damage the lip of oil seal press-fitted in the case. 7. Remove the manual plate from the shifter arm shaft, and remove the shift connecting rod of the manual valve.
8. Remove the manual plate and parking rod. 9. Remove the manual valve. 10. Remove the extension case. Extension Case > REMOVAL 11. Remove the parking support. |
Installation
CAUTION:• For parts which are not reusable, always use new parts.• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.• During the installation, make sure that the marking of ABS wheel speed sensor harness ...