Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr580) / Transmission mounting system / Removal

1. TRANSMISSION REAR CROSSMEMBER AND REAR CUSHION RUBBER

1. Disconnect the ground terminal from battery sensor. NOTE

2. Lift up the vehicle.

3. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL

4. Remove the center exhaust cover.

5. Set the transmission jack under the transmission. Make sure that the support plate of transmission jack does not touch the oil pan.

6. Remove the transmission rear crossmember.

7. Remove the rear cushion rubber.

Inspection

• Check the crossmember for bends or damage.• Check that the cushion rubber is not stiff, cracked or otherwise damaged. ...

Other materials:

Dtc p0616 starter relay "a" circuit low
1. MODEL WITHOUT PUSH BUTTON STARTDTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:Engine Electrical System ENGINE TYPE ...