Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr690) / Reduction driven gear / Removal

1. Remove the transmission from the vehicle. Automatic Transmission Assembly > REMOVAL

2. Remove the extension case. Extension Case > REMOVAL

3. Remove the rear drive shaft. Rear Drive Shaft > REMOVAL

4. Remove the transfer clutch assembly. Transfer Clutch > REMOVAL

5. Remove the transfer reduction driven gear assembly. Transfer Reduction Driven Gear > REMOVAL

6. Remove the intermediate case. Intermediate Case > REMOVAL

7. Remove the forward clutch assembly. Forward Clutch Assembly > REMOVAL

8. Remove the snap ring.

9. Remove the reduction driven gear assembly.

10. Remove the straight pin.

Adjustment

1. Measure clearance “A” between snap ring and transmission case.Specification:0.05 — 0.25 mm (0.002 — 0.01 in)2. If clearance “A” is out of standard, select the snap ring ...

Other materials:

Installation
1. Before installation, check the following items.• Cable and rod are free from deformation.• Grease is applied sufficiently to rod joints.If grease is insufficient, add it as necessary before assembling the rod.2. Install the latch and actuator assembly - front.CAUTION:Do not re-use the ...