Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
CAUTION: Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part. 1. Remove the transmission from the vehicle. Automatic Transmission Assembly > REMOVAL 2. Remove the transmission cover on the transmission upper side.
3. Remove the secondary speed sensor harness connector. 4. Remove the secondary speed sensor.
|
Inspection
1. Remove the bulkhead harness connector from TCM. Transmission Control Module (TCM) > REMOVAL2. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD3. Set the probe of oscillo ...
Other materials:
Installation
1. Clean the mating surface of the extension case and intermediate case.2. Select the thrust needle bearing. Rear Drive Shaft > ADJUSTMENT3. Select the shim for transfer reduction driven gear. Transfer Reduction Driven Gear > ADJUSTMENT4. Install the selected thrust needle bearing to transfer clut ...
© 2017-2024 Copyright www.sulegacy.com
