1. SOLENOID UNIT 1. Remove the select lever with the select cable connected. Select Lever > REMOVAL 2. Remove the spacer and gasket. Select Lever > REMOVAL 3. Remove the harness connector from the select lever COMPL. 4. Remove the harness from the select lever COMPL. 5. Raise the claw using a flat tip screwdriver with a thin tip, and remove the solenoid unit from the select lever COMPL. 6. Remove the terminal of the solenoid unit using a flat tip precision screwdriver with a tip width of 1.3 mm (0.05 in) or less, KTC connector terminal tool ECC-1T or equivalent.
2. “P” RANGE SWITCH The “P” range switch cannot be removed as a single unit. Therefore, replace the AT select lever COMPL. Select Lever > REMOVAL |
Dtc p2530 ignition switch run position circuit
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Faulty TCM operationWIRING DIAGRAM:• ENGINE TYPE FBCVT control system CVT Control System > WIRING DIAGRAM• ENGINE TYPE EZCVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK CONNECTOR.Check t ...