1. Lift up the vehicle, and then remove the front wheels. 2. Remove the nut - axle. CAUTION: Do not loosen the nut - axle while the front axle is loaded. Doing so may damage the hub unit COMPL. (1) Lift the crimped section of the nut - axle. (2) Remove the nut - axle using a socket wrench while depressing the brake pedal. 3. Remove the disc brake assembly. Front Disc Brake Assembly > REMOVAL 4. Remove the disc rotor. Front Disc Rotor > REMOVAL 5. Remove the bolts, and remove the front ABS wheel speed sensor. 6. Remove the hub unit COMPL - front axle. CAUTION: • Do not get closer the tool which charged magnetism to magnetic encoder. • Be careful not to damage the magnetic encoder.
NOTE: If it is hard to remove, use the ST. Preparation tool: ST1: AXLE SHAFT PULLER (926470000) ST2: AXLE SHAFT PULLER PLATE (28099PA110) |
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.3. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move it to the left side wheel apron.4. Disconnect the connector (A ...