Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. DATA COMMUNICATION MODULE 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the center grille assembly. Air Vent Grille > REMOVAL 3. Remove the heater control assembly. Control Panel > REMOVAL 4. Remove the audio assembly or navigation assembly. Audio > REMOVAL 5. Remove the data communication module. (1) Remove the screws. (2) Remove the audio bracket or navigation bracket, and then remove the data communication module. CAUTION: Do not drop or apply any impact to the data communication module.
2. BACKUP BATTERY 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the data communication module. Data Communication Module > REMOVAL 3. Remove the backup battery. (1) Remove the screws, and then remove the battery cover. Preparation tool: TORX® T10 (2) Disconnect the connector and remove the backup battery.
|
Installation
1. DATA COMMUNICATION MODULECAUTION:After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.1. Install th ...
Other materials:
Inspection
CAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emission of smoke or causing a fire.1. Park the vehicle on a level surface.2. Remove the oil level gauge and wipe away the oil.3. Reinsert the oil level gauge all the way. Be sure that the oil le ...
