1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE 2. Remove the heater control assembly. Control Panel > REMOVAL 3. Remove the cover assembly - front and the console box assembly. Console Box > REMOVAL 4. Release the claws, and then remove the panel center LWR. 5. Remove the screws and remove the pocket assembly - CTR. 6. While pressing the claw, press it in from the rear to remove the unit assembly - AUX. |
Preparation for overhaul procedure
1. Clean oil, grease, dirt and dust from the transmission.2. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.3. Tighten the drain plug using TORX® bit T70.NOTE:Use a new gasket.Tightening torque:44 N·m (4.5 kgf-m, 32.5 ft-lb) (aluminum gasket, ...