1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the combination meter assembly. Combination Meter > REMOVAL 3. Remove the center grille assembly. Center Console > REMOVAL 4. Remove the heater control assembly. Center Console > REMOVAL 5. Remove the audio assembly or navigation assembly. Audio > REMOVAL 6. Remove the GPS antenna assembly. (1) Disconnect the GPS antenna assembly connector on the audio unit or navigation unit side, and tie a string to the connector. NOTE: • A string makes operation easier during installation. • For the model with telematics, also tie a string to the connector on the data communication module side. (2) Remove the screw and harness clamp, and pull out the GPS antenna assembly from the combination meter side. • Model without telematics • Model with telematics (3) When the GPS antenna assembly is pulled out, remove the string attached to the connector in step (1). |
List
• List of freeze frame dataDisplayContentUnitECU Power Supply Voltage (IG)Display of input voltage of stereo cameraVEngine SpeedEngine speedrpmAccel opening angleAcceleration opening angle signal%Brake Fluid Target PressureTarget value of brake fluid pressureMPaMaster Cylinder Actual Fluid Pre ...