Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. FRONT DOOR CAUTION: Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION 1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE 2. Remove the trim panel - front door. (1) Attach the protective tape (a). (2) Open the cover and remove the screw. (3) Remove the clips, and remove the trim panel - front door from the panel assembly - front door.
(4) Detach the door lock cable (a) and door open cable (b) from the remote assembly - door.
(5) Disconnect the harness connector and remove the trim panel - front door. 3. Remove each part as required. • Remote assembly - door: Front Inner Remote > REMOVAL • Switch - power window main: Power Window Control Switch > REMOVAL • Weather strip - door INN: Door Trim > DISASSEMBLY 2. REAR DOOR 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the trim panel - rear door. (1) Attach the protective tape (a). (2) Open the cover and remove the screw. (3) Remove the clips, and remove the trim panel - rear door from the panel assembly - rear door.
(4) Detach the door lock cable (a) and door open cable (b) from the remote assembly - door.
(5) Disconnect the harness connector and remove the trim panel - rear door. 3. Remove each part as required. • Remote assembly - door: Rear Inner Remote > REMOVAL • Switch - power window sub: Power Window Control Switch > REMOVAL • Weather strip - door INN: Door Trim > DISASSEMBLY |
Door trim
...
Assembly
1. Bend the claws while pushing the weather strip - door INN against the trim panel - door so that there is no gap.CAUTION:Beware of the direction of folding the claws.(a)Rivet(b)Direction of folding ...
Other materials:
Dtc p0720 output shaft speed sensor circuit
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Shock occurs when selecting shift position.• Shift control malfunctionWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK FUSE.1) Turn the ignition switch to OFF.2) Check the ...
