1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the bumper face - front. (1) Remove the clips at the upper side of the bumper face - front. (2) Remove the clips from the fender. (3) Remove the clips at the lower side of the bumper face - front. (4) Disconnect the fog light assembly connector. (5) While pushing up the lower side (a) of the bumper face - front, release the engagement in the order from (b) to (i). CAUTION: Do not pull forcibly. It may damage the flange section on the bumper face - front side when it comes off from the claws of the bracket - front bumper. NOTE: Detach the opposite side in the same manner. 3. Remove the energy absorber foam - front. 4. Remove the bolts and clips, disconnect the connector and remove the active grille shutter. (H4 model) 5. Remove the bolts, and remove the bumper beam COMPL - front. NOTE: After the bolts are removed, raise the bumper beam COMPL - front a little to remove it from vehicle body. 6. Remove the under cover - front. Front Under Cover > REMOVAL 7. Remove the bolts, and pull the bracket - front center LWR to remove. 8. Remove the bolts and clips, and remove the bracket - front bumper corner. 9. Remove the bracket - front bumper side. (1) Remove the bolts and screws. (2) Remove the claws from behind the fender COMPL - front, and remove the bracket - front bumper side. 10. Remove the fog light assembly - front. Front Fog Light Assembly > REMOVAL |
Inspection
1. KEYLESS TRANSMITTER BATTERY1. Measure the keyless transmitter battery voltage.Preparation tool:Circuit testerNOTE:Complete the measurement within 5 seconds because the battery discharges during measurement.Battery terminalInspection ConditionsStandard(+) — (−)Connect resistor (A) 47 -2.5 ...