Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

1. SEDAN MODEL

1. Disconnect the ground terminal from battery sensor. NOTE

2. Remove the trunk room mat.

3. Remove the light assembly - rear combination. Rear Combination Light Assembly > REMOVAL

4. Remove the bumper face - rear.

(1) Remove the clips inside the wheel housing.

(2) Remove the screws from trunk opening.

(3) Remove the clips at the lower side of the bumper face - rear.

(4) Detach (b) and (c) while pulling up (a) of the bumper face - rear.

(5) Detach (e) while pulling up (d) of the bumper face - rear.

(6) Detach the opposite side in the same manner.

(7) Detach in order from (f) to (h) while pulling up the center part of the bumper face - rear.

CAUTION:

Do not pull forcibly. It may damage the flange section on the bumper face - rear side when it comes off from the claws of the bracket - rear bumper.

5. Remove the energy absorber foam - rear.

6. Remove the nuts, and remove the bumper beam COMPL - rear.

7. Remove bumper brackets.

(1) Remove the bolts and screws.

(2) Turn over the trim panel - trunk side, and detach the claw of the clip from the back side.

2. OUTBACK MODEL

1. Disconnect the ground terminal from battery sensor. NOTE

2. Remove the light assembly - rear combination. Rear Combination Light Assembly > REMOVAL

3. Remove the bumper face - rear.

(1) Remove the clips inside the wheel housing.

(2) Remove the screws from rear gate opening.

(3) Remove the clips at the lower side of the bumper face - rear.

(4) Detach (b) and (c) while pulling up (a) of the bumper face - rear.

(5) Detach (e) while pulling up (d) of the bumper face - rear.

(6) Detach the opposite side in the same manner.

(7) Detach in order from (f) to (h) while pulling up the center part of the bumper face - rear.

CAUTION:

Do not pull forcibly. It may damage the flange section on the bumper face - rear side when it comes off from the claws of the bracket - rear bumper.

4. Remove the energy absorber foam - rear.

5. Remove the nuts, and remove the bumper beam COMPL - rear.

6. Remove bumper brackets.

(1) Remove the mat floor - rear, and remove the trim panel - rear skirt.

CAUTION:

Do not lift the trim panel - rear skirt from the edge. Doing so may damage the part.

Do not reuse the clips. Once the clip is removed, its holding force is reduced. Be sure to replace it with a new clip.

(2) Remove the trim panel - rear apron. Rear Quarter Trim > REMOVAL

(3) Remove the bolts and screws.

(4) Detach the claw of the clip from the back side.

Installation
1. SEDAN MODELCAUTION:Before installing the bumper face, match the claws on the bracket - rear bumper with the engaging position of flange section on the bumper face side. If the engaging position is ...

Rear gate garnish
...

Other materials:

Installation
CAUTION:• When installing the VDCCM&H/U to the bracket - hydraulic unit, make sure that there is no oil adhered to the bolts and the threads of VDCCM&H/U. If the oil is adhered, degrease it carefully before tightening.• Connect the VDCCM&H/U connector securely.1. Install the bracket - hy ...

© 2017-2024 Copyright www.sulegacy.com