1. Remove the trim panel - rear gate UPR. (1) Remove the claws on the trim edge. (2) Release the claws in the center of trim, and remove the trim panel - rear gate UPR. 2. Remove the trim panel - rear gate pillar side. (1) Disconnect the rod - power rear gate before removing the trim panel - rear gate pillar side LH. (Only for models with power rear gate) CAUTION: For the disconnection procedure of the rod - power rear gate, refer to “REMOVAL”, “Power Rear Gate Rod” in the “POWER REAR GATE” section and observe the precautions for removal. Power Rear Gate Rod > REMOVAL (2) Release the claws. (3) Remove the claws on the bottom of trim, and remove the trim panel - rear gate pillar side. 3. Remove the trim panel - rear gate LWR. (1) Remove the power rear gate inner switch and disconnect the connector. (Only for models with power rear gate) NOTE: Insert a flat tip screwdriver wrapped with protective tape into the slit on the left. (2) Remove the cover - grip, and remove the bolts. NOTE: Insert a flat tip screwdriver wrapped with protective tape into the side slit. (3) Remove the clips, and remove the trim panel - rear gate LWR. |
Adjustment
Adjust the clearance around the trunk lid COMPL as follows.PartStandardATrunk lid COMPL and Panel - side outer3.5±1.0 mm (0.14±0.04 in)BSurface level gap between Trunk lid COMPL and Panel - side outer0±1.0 mm (0±0.04 in)CSurface level gap between Trunk lid COMPL and Panel - side outer−0.5 ...