Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. SEDAN MODEL Remove the clips and detach the side garnish assembly.
2. OUTBACK MODEL 1. Remove the clips and detach the side garnish assembly.
2. Remove the garnish assembly - door and the garnish assembly - rear quarter. (1) Attach the protective tape to the periphery of the garnish. (2) Heat the garnish section for 3 — 5 minutes at 40°C — 60°C (104°F — 140°F) using a heat light or a drier. CAUTION: Be careful not to burn yourself. (3) Separate the bonded part of double sided tape with a nylon cord or equivalent. (4) Release the clips, and remove the garnish assembly. |
Side garnish
...
Installation
1. SEDAN MODELCAUTION:Make sure that there is a gasket attached on the clip of the garnish assembly. If a gasket is not attached, water leakage may occur.Install the side garnish assembly.2. OUTBACK M ...
Other materials:
Preparation tool
1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — (Newly adopted tool)SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.2. GENERAL TO ...
