Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Front suspension / Front arm / Removal

1. Lift up the vehicle, and then remove the front wheels.

2. Remove the under cover - front. Front Under Cover > REMOVAL

3. Remove the front arm.

(1) Pull out the cotter pin (a).

(2) Remove the castle nut (b) and bolt.

(3) Extract the front arm (c) from the housing assembly - front axle.

CAUTION:

Use a tool appropriate to the structure, and be careful not to damage the boot of the joint while removing. The boot may be damaged depending on the tool used.

Preparation tool:

Tie-rod ball joint puller

(4) Remove the bolts, then remove the front arm.

Assembly

1. BUSHING FRONT - FRONT ARM1. Before assembly, inspect the following items and replace any faulty part with a new one.• Check the front arm for damage or cracks, and replace if defective.• ...

Other materials:

Assembly
1. Install the oil drain plug and overflow drain plug.NOTE:Overflow plug of differential gear oil is temporarily attached.2. Install all plugs.NOTE:Use new O-rings.Tightening torque:25 N·m (2.5 kgf-m, 18.4 ft-lb)3. Install the transmission hanger and transmission radio ground cord.Tightening ...