Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
WARNING: Place “NO OPEN FLAMES” signs near the working area. CAUTION: • Be careful not to spill fuel. • If the fuel gauge indicates that two thirds or more of the fuel is remaining, be sure to drain fuel before starting work to avoid the fuel to spill. NOTE: The fuel level sensor is built in fuel pump assembly. 1. Remove the fuel pump assembly. Fuel Pump > REMOVAL 2. Disconnect the connector (A) of the fuel level sensor and pull out the fuel pump harness and fuel level sensor harness from the clip.
3. While pressing the claw (A) of the fuel level sensor, slide the fuel level sensor in the direction of the arrow, and remove the fuel level sensor.
|
Inspection
1. Check that the fuel level sensor has no damage.2. Measure the fuel level sensor float position.NOTE:When inspecting the fuel level sensor, perform the work with the sensor installed to the fuel pum ...
Other materials:
Dtc b2a02 lte2 antenna circuit
DIAGNOSIS START CONDITION:When ignition switch is ON.DTC DETECTING CONDITION:Any of the followings continues for 5 seconds or more.• LTE2 impedance is more than 1 M-. (Detached antenna, etc.)• LTE2 impedance is less than 1 k-. (Short-circuited antenna, etc.)TROUBLE SYMPTOM:• Telema ...
