1. Remove the collector cover. (1) Carefully pull up the rear of collector cover at two positions (A). (2) Carefully pull up the front of collector cover at two positions (B) while moving it forward. 2. Disconnect the ground terminal from battery sensor. NOTE 3. Disconnect the connector (A) from the oil temperature sensor, and remove the oil temperature sensor from the cylinder block. |
General diagnostic table inspection
SymptomsPossible causeCorrective actionAT select leverStarter does not run.Adjust the select cable and inhibitor switch, or inspect the circuit.Back-up light does not illuminate.Adjust the select cable and inhibitor switch, or inspect the circuit.AT shift lock system does not operate normally.Adjust ...