1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the heater control assembly. (1) Release the clips and claws, then detach the control module cover. (2) Release the screws and clips, then detach the heater control assembly. CAUTION: • Insert a flat tip screwdriver wrapped with a protection tape into the position (a) shown in the figure, and move it in the arrow direction to remove the clip. When both clips are removed, pull out the heater control assembly by hand inserted through the space. • Be careful not to damage the clips and the control panel. |
Removal
1. Remove the transmission from the vehicle. Automatic Transmission Assembly > REMOVAL2. Remove the extension case. Extension Case > REMOVAL3. Remove the rear drive shaft. Rear Drive Shaft > REMOVAL4. Remove the transfer clutch assembly. Transfer Clutch > REMOVAL5. Remove the transfer reduction ...